Casting on for 2 socks at a time on Magic Loop

Nine easy steps to casting on for Two socks at a time on Magic Loop. Step 1 cast on all your stitches for sock 1. So far, so good.

Slide sock #1 on down the needle, out of the way. Next, cast on all the stitches for sock #2.

Push all the stitches to the other end of the needles. See how the tails and the working yarn are at the opposite end from the tip of the needle (pictured lower right)?

On the sock closest to the needle end (sock #1), divide the stitches in half. Bend the the cable so half the stitches are on the needle and the other half are on the cable. Sock #2 is shown at the bottom (don't worry about it now). On the right you will see the free needle which will become your "working" needle.

Make sure your stitches are not twisted. Use the needle shown at the right to work the stiches on the needle. Make sure to snug up the yarn on the first two stitches to avoid "ladders".

The first half of sock #1 has been worked. The needle in the back will have the worked stitches and the working yarn will be dangling from this. This is the needle you want to pull out to become your "working" needle. Then you will knit the second half of sock #1.

Here's a close up to show you better.

Here's the needle (upper right) pulled out ready to work the second half of sock #1.

Now you're ready for sock #2. Push these stitches up to the end of the unused needle.

Again, split the stiches of sock #2 in half. Half the stitches on the needle and the other half on the cable below. (Sock #1 is on the right and sock #2 is on the left.)

When you are done with both halves of sock #2 you should have something that looks like this.